TransAct Ithaca 90PLUS Series Programmer's Manual page 132

Product Self Tests
Automatic
line feed
Automatic
carriage
return
Form length
Paper out
mode
Receipt paper
Slip top
adjustment
Page 120
PcOS Series 90PLUS
An automatic line feed feature can be set as a default
where all [CR]'s will have a [LF] added. If automatic line
feed is set to "on," the feature is activated.
Off
On
An automatic line feed feature can be set as a default
where all [LF]'s will have a [CR] added. If the automatic
carriage return is set to "on," the feature is activated.
Off
On
The default form length can be set from 3 to 17 inches. This
configuration affects how the [FF] command operates.
3 to 17 inches
The paper out features of this printer can be configured in
one of four ways.
1. Disabled - which prevents the printer from detecting the
end of the receipt paper
2. Fault - which sets a PE fault as soon as paper low is
detected
3. No warning - which sets PE to fault after a set length of
paper is fed and paper low is detected
4. Warning - which warns the operator when paper low is
detected and then sets PE to fault after a set length of
paper is fed.
Disabled
Fault
No warning (but is measured)
Warning
In "no warning" or "warning" modes, the length of receipt
paper that is fed after paper low is detected is measured.
When a set length is reached the printer will insure a PE
fault. The receipt paper setting specifies the length of
receipt paper that is fed. The length can be set to 1 foot (30
cm); 1-ply (about 8 feet or 244 cm); 2-ply (about 4 feet or
122 cm); or 3-ply (about 2 feet or 61 cm). This should be
specified based on the type of paper you are going to use.
1 foot from warning to PE
1-ply
2-ply
3-ply
The position of the top of the form is adjustable from -8/72
to +7/72. The adjustment compensates for form variations.
-8/72 to +7/72 in 1/72 intervals (Default is 0).
Rev Q
Programmer's Guide
Recommendation
11
0
11/07/05