TransAct Ithaca 90PLUS Series Programmer's Manual page 72

Printer Control Codes
Station Control
Function
ASCII
Hexadecimal
Decimal
IPCL
EPOS
Description
Note
Function
ASCII
Hexadecimal
Decimal
IPCL
EPOS
Description
Function
ASCII
Hexadecimal
Decimal
IPCL
EPOS
Description
Page 60
PcOS Series 90PLUS
Select paper-error operation
[ESC] p <n>
1BH 70H
<27> <112>
&%PE <m > <m >
1 2
[ESC] c 3 <n>
The [ESC] p <n> command selects the operation of the receipt paper-status
sensor.
Where n bits: n IPCL
0
1
15
0 00-15
16 16-31
32 32-47
The default mode is specified in the printer configuration.
Typical values for Mode 2 are 8 feet (244 cm) with 1-ply, 4 feet (122 cm)
with 2-ply, and 2 feet (61 cm) with 3-ply paper.
Disable the paper out sensor
[ESC] 8
1BH 38H
<27> <56>
&%PF
none
The [ESC] 8 command is intended to temporarily disable the paper out
sensor. The printer will not stop printing or go off-line when it senses that it
is out of paper. The [ENQ] command will still return paper out status.
Enable the paper out sensor
[ESC] 9
1BH 39H
<27> <57>
&%PO
none
The [ESC] 9 command is intended to reverse the effect of the disable paper
out sensor command. If the printer is out of paper when this command is
issued, it will go off-line.
Rev Q
Programmer's Guide
76543210
paper length to fault
----xxxx
immediate
----0000
1 foot
----0001
15 feet
----1111
mode
yyyy----
no fault generation
0000----
(Paper error is disabled.
Paper-error off is for
validation-only printers).
immediate fault after n feet
0001----
paper low warning, then
0010----
fault with visual warning
11/07/05