Set Torque Mode - KaVo ESTETICA E30 Instructions For Use Manual

Instructions for use ESTETICA E30
4 Operation | 4.12 Using the KL 703 LED in ENDO mode (optional accessory)
Parameters
Speed
Torque
Incorrectly set parameters.
Injury or property damage from incorrect input values.
4 Check all input values before use (e.g. transmission ratio, transmission
factor, torque, etc.).

4.12.3 Set torque mode

Three different torque modes are available:
▪ Auto-reverse
▪ Torque Control only
▪ Autorev / Forward
4 Press the "Up" or "Down" key to select the desired torque mode.
ð Torque mode is shown on the display and is effective immediately.
Torque mode Torque Control only
4 Press the foot pedal.
ð The motor starts by rotating clockwise (unless selected otherwise).
The torque is limited to the set threshold. The speed decreases, depending on
load, all the way to a standstill.
The rotation is always clockwise.
There is a beep when the set torque threshold is reached.
4 Push 4-way button on the foot control upward in order to switch to counter-
clockwise rotation.
Torque mode Autorev / Forward
4 Press the foot pedal.
ð The motor starts by rotating clockwise (unless selected otherwise).
When the set torque is reached, a signal sound is emitted, and the motor
switches to counterclockwise rotation. After the set time, the motor automatic-
ally reverts to clockwise rotation. The time can be set in the option menu (Op-
tion 3).
Also refer to:
4.8.6 ENDO menu (optional), Page 65
NOTE
The motor's rotational direction can be reversed with the cross switch on the
footswitch in all torque modes.
Values
100 to 6000 rpm
Transmission ratio 1:1: 0.15 to 2.50
Ncm
Transmission ratio 3:1: 0.4 to 8.0 Ncm
CAUTION
90 / 124