"Paving parameters" menu
Menu for showing and adjusting the paving parameters.
- (1) Current course thickness parameter
- The following course thickness parameters can be selected:
- (1a) Surface course >, low paving speed
- (1b) Surface course >>, high paving speed
- (1c) Binder course >, low paving speed
- (1d) Binder course >>, high paving speed
- (1e) Foundation
The speeds for every course thickness parameter have been stored in the factory for
A
all conveying and compacting elements.
Depending on the course thickness, the conveying rate increases slowly or faster at
the start of paving.
Preferred parameters or parameters configured to the paving material can be saved
in the memory for later use.
Factory resets for the values are possible.
A
1a
1
2
4
6
1b
1c
3
5
7
1d
1e
D 23.18 17