Table of Contents
Advertisement
High-pressure filter (4)
Replace the filter elements when the in-
terval has been reached
The filter (B) is in the engine compart-
ment on the left of the vehicle.
During the run-in time, the filter element
A
can be cleaned with cleaning solvent,
later it will have to be changed.
- Loosen the fittings (C) and remove the filter housing (B).
- Fix the filter in a vice.
- Loosen and unscrew the screw-in
neck (D) with a screw wrench.
Put a vessel underneath to collect the
A
draining oil.
- Remove the screw-in neck with strain-
er element (D).
- Shake any remaining oil out of the
housing (E) into a vessel for used oil,
then clean the filter housing with
cleaning solvent.
- Check that the O-ring (F) at the screw-
in neck is in perfect condition, replace
if necessary.
- Push the screw-in neck with strainer
element (D) carefully into the housing
(E) and screw in as far as it will go.
Tighten with a screw wrench (torque
120 +/- 5 Nm)
- Start trial operation and check the
tightness of the filter.
Replace the seal ring whenever the filter
A
cartridge is replaced.
F 60.18 10
C
B
F
D
D
E
Advertisement
Table of Contents
