Table of Contents
Advertisement
1.1
Starting the paver finisher
Before starting the paver finisher
Before starting the diesel engine and beginning operation, the following steps must
be performed:
- Daily maintenance of the paver finisher (see chapter F).
Check the operating hours counter to determine whether further maintenance work
m
should be conducted.
- Check the safety devices and protective devices.
"Normal" starting
- Set the drive lever (13) to the centre position and the travel drive preselector (15)
to minimum.
- Insert the ignition key (11) in position "0".
It is impossible to start the vehicle if an emergency stop button (10) / (120) is depressed.
A
(Error shown on the display)
- Turn ignition key (11) to position 1 and wait for the preheat check (A) to go off.
- Press the starter button (12) to start the engine. Run the starter continuously for a
maximum of 20 seconds, then take a break for 2 minutes!
If the engine does not start and the error message indicator lamp (B) flashes, then the
A
electronic engine control system has activated the start inhibit.
To deactivate the start inhibit, turn the system off with the ignition key (1) for approx. 30 s.
m
If the engine still has not started after two attempts, ascertain the cause!
f
Do not use aerosol types such as ether as starting aid. This can cause an explosion
and lead to personal injuries.
D 41.18 6
Advertisement
Table of Contents
