Table of Contents
Advertisement
If a different level of slack is detected during the measurement process, proceed
A
as follows:
- Screw head section for flat nipple
(toolbox) onto the grease gun.
- Refill the chain tensioner with grease
at the filler connection (A), then re-
move the grease gun.
- Check the chain tension once again,
as described above.
If the tension is too high: see section
A
"Relieving the chain".
Repeat this procedure on both drive units!
A
Relieving the chain:
f
The grease in the tensioning element is
under pressure. Carefully and slowly un-
screw the filling valve, but not too far.
- Unscrew the lubricating nipple (A) on
the grease tensioner using a tool until
the grease is able to emerge from the
nipple's lateral hole.
The idler wheel moves back independ-
A
ently or must be reset manually.
F 70.18 8
x
A
Advertisement
Table of Contents
