Calibrate Analog Input Ports - Digi IX20 User Manual

Command line interface
src_addr: Chooses an alternative source address. Note that you must select the address of one of the
interfaces. By default, the address of the outgoing interface is used.
tos: For IPv4, set the Type of Service (ToS) and Precedence value. Useful values are 16 (low delay) and
8 (high throughput). Note that in order to use some TOS precedence values, you have to be super
user. For IPv6, set the Traffic Control value. A value of -1 specifies that no value will be used.
(Minimum: -1, Default: -1)
waittime: Determines how long to wait for a response to a probe. (Minimum: 1, Default: 5)
pausemsecs: Minimal time interval between probes. (Minimum: 0, Default: 0)
packetlen: Total size of the probing packet. Default 60 bytes for IPv4 and 80 for Ipv6. A value of -1
specifies that the default value will be used. (Minimum: -1, Default: -1)
debug: Enable socket level debugging.
dontfragment: Do not fragment probe packets.
icmp: Use ICMP ECHO for probes.
nomap: Do not try to map IP addresses to host names when displaying them.
bypass: Bypass the normal routing tables and send directly to a host on an attached network.

calibrate analog input ports

Calibrate the analog input ports (voltage-, and current-mode separately) on a custom low and high set
point.
Syntax
ain calibrate <port> low/high <reference voltage/current>
Parameters
port:
reference voltage/current: has a minimum of 0
low|high
ain calibrate 12 low 0
ain calibrate 12 high 100
IX20 User Guide
Command line reference
1188