Digi IX20 User Manual page 1040

System administration
This options is only available if Central Management is disabled; see
more information.
(config)> system schedule maintenance modem_fw_update true
(config)>
6. (Optional) Configure automated checking for device firmware updates:
a. Device firmware update check is enabled by default. This enables to automated
checking for device firmware updates. To disable:
(config)> system schedule maintenance firmware_update_check device
false
(config)>
b. Set how often automated checking for device firmware should take place:
(config)> system schedule maintenance frequency value
(config)>
where value is either daily, weekly, or monthly. daily is the default.
7. Save the configuration and apply the change
(config)> save
Configuration saved.
>
8. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
7. (Optional) Configure automated checking for device firmware updates:
a. Device firmware update check is enabled by default. This enables to automated
checking for device firmware updates. To disable:
(config)> system schedule maintenance firmware_update_check device
false
(config)>
b. Set how often automated checking for device firmware should take place:
(config)> system schedule maintenance frequency value
(config)>
where value is either daily, weekly, or monthly. daily is the default.
8. Save the configuration and apply the change
(config)> save
Configuration saved.
>
9. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
IX20 User Guide
Schedule system maintenance tasks
Central management for
1040