Digi IX20 User Manual page 1095

Hide thumbs Also See for IX20:

Table of Contents

iii. To change the status interval:

(config)> system log event dhcpserver status_interval value

where value is any number of weeks, days, hours, minutes, or seconds, and takes the

format number{w|d|h|m|s}.

For example, to set the status interval to ten minutes, enter either 10m or 600s:

(config)> system log event dhcpserver status_interval 600s

6. (Optional) See

servers to which log messages will be sent.

7. Save the configuration and apply the change

(config)> save

Configuration saved.

8. Type exit to exit the Admin CLI.

Depending on your device configuration, you may be presented with an Access selection

menu. Type quit to disconnect from the device.

IX20 User Guide

Configure syslog servers

for information about configuring remote syslog

Configure options for the event and system logs