Digi IX20 User Manual page 1147

Command line interface
serial
service
system
vpn
(config)>
2. You can then display help for the additional configuration commands. For example, to display
help for the config service command, use one of the following methods:
At the config prompt, enter service ?:
n
(config)> service ?
At the config prompt:
n
a. Enter service to move to the service node:
b. Enter ? to display help for the service node:
Either of these methods will display the following information:
config> service ?
Services
Additional Configuration
------------------------------------------------------------------------
--
dns
mdns
multicast
ntp
remote_control
snmp
ssh
telnet
web_admin
(config)> service
3. Next, to display help for the service ssh command, use one of the following methods:
At the config prompt, enter service ssh ?:
n
(config)> service ssh ?
IX20 User Guide
Serial
Services
System
VPN
(config)> service
(config service)>
(config service)> ?
DNS
Service Discovery (mDNS)
Multicast
NTP
Remote control
SNMP
SSH
Telnet
Web administration
Configuration mode
1147