Digi IX20 User Manual page 1020

System administration
1. Locate the ERASE button on your device.
2. Press the ERASE button perform a device reset. The ERASE button has the following modes:
n Configuration reset:
Press and release the ERASE button .
l
The device reboots automatically and resets to factory defaults. This does not
l
remove any automatically generated certificates and keys.
n Full device reset:
After the device reboots from the first button press, immediately press and release
l
the ERASE button again.
The device reboots again and resets to factory defaults, as well as also removing
l
generated certificates and keys.
3. After resetting the device:
a. Connect to the IX20 by using the serial port or by using an Ethernet cable to connect the
IX20 ETH2 port to your PC.
b. Log into the IX20:
User name: Use the default user name: admin.
Password: Use the unique password printed on the bottom label of the device (or the
printed label included in the package).
c. (Optional) Reset the default password for the admin account. See
password for the admin user
Reset the device with the revert command
You can reset the device to the default configuration without removing scripts, keys, and logfiles by
using the revert command:
1. Select the device in Remote Manager and click Actions > Open Console, or log into the IX20
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
IX20 User Guide
Erase device configuration and reset to factory defaults
for further information.
Change the default
1020