Digi IX20 User Manual page 1086

Diagnostics
1. Select the device in Remote Manager and click Actions > Open Console, or log into the IX20
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. Use the show event
> show event
Timestamp
---------------- ------- --------- --------------------------------------
-----
Nov 26 21:42:37
intf=eth1~type=ethernet~rx=11332435~tx=5038762
Nov 26 21:42:35
+0000~uptime=3 hours, 0 minutes, 48 seconds
...
>
3. (Optional) Use the show event number num command to limit the number of lines that are
displayed. For example, to limit the event list to the most recent ten lines:
> show event number 10
Timestamp
---------------- ------- --------- --------------------------------------
-----
Nov 26 21:42:37
intf=eth1~type=ethernet~rx=11332435~tx=5038762
Nov 26 21:42:35
+0000~uptime=3 hours, 0 minutes, 48 seconds
...
>
4. (Optional) Use the show event table value command to limit the number of lines that are
displayed. Allowed values are error, info, and status. For example, to limit the event list to
only info messages:
> show event table info
Timestamp
---------------- ------- --------- --------------------------------------
-----
Nov 26 22:01:26
name=admin~service=cli~state=opened~remote=192.168.1.2
Nov 26 22:01:25
name=admin~service=cli~state=closed~remote=192.168.1.2
...
>
IX20 User Guide
command at the Admin CLI prompt:
Type Category Message
status stat
status system local_time=Thu, 08 Aug 2019 21:42:35
Type Category Message
status stat
status system local_time=Thu, 08 Aug 2019 21:42:35
Type Category Message
info user
info user
View system and event logs
1086