Digi IX20 User Manual page 1037

System administration
c. For Duration window, select the amount of time that the maintenance tasks will
d. For Frequency, select whether the maintenance window will be started every day,
If Check if Python Out-of-Service is set, the maintenance window will only start if the
n
Python Out-of-Service is set. See
information.
7. If Central Management is disabled, click Device firmware update to instruct the system to
look for any updated device firmware during the maintenance window. If updated firmware is
found, it will then be installed. This options is only available if Central Management is
disabled; see
8. If Central Management is disabled, click to enable Modem firmware update to instruct the
system to look for any updated modem firmware during the maintenance window. If updated
firmware is found, it will then be installed. Modem firmware update looks for updated firmware
both on the local device and over the network, using either a WAN or cellular connection. This
options is only available if Central Management is disabled; see
more information.
9. (Optional) Configure automated checking for device and modem firmware updates:
a. Click to expand Firmware update check.
b. Device firmware update check is enabled by default. This enables the automated
checking for device firmware updates.
c. Modem firmware update check is enabled by default. This enables the automated
checking for modem firmware updates.
d. For Frequency, select how often automated checking for device and modem firmware
should take place. Allowed values are Daily, Weekly, and Monthly. The default is Daily.
10. Click Apply to save the configuration and apply the change.

Command line
1. Select the device in Remote Manager and click Actions > Open Console, or log into the IX20
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
IX20 User Guide
If Duration window is set to one or more hours, the minutes field in Start time
l
is ignored and the duration window will begin at the beginning of the specified
hour.
be run. If Immediately is selected, all scheduled tasks will begin at the exact time
specified in Start time.
or once per week.
Central management for more information.
Schedule system maintenance tasks
Use Python to set the maintenance window
Central management
for further
for
1037