Opening The Setting Menu; Changing The Basic Setting Of The Control - Henny Penny FlexFusion FM08-454-G Installation Manual

6.3.1 Opening the Setting menu

Prerequisite Unit switched on

6.3.2 Changing the basic setting of the control

By entering the password "2100", the basic setting for the installation
can be displayed and changed.
1. Turn the Selection operating knob to the Settings symbol.
The indicator light illuminates.
The left display reads "PASS".
The right display flashes "- - - -".
2. Use the right rotary knob to set the password.
The right display shows the password set.
3. Press the "Start Stop" button.
Use the left rotary knob to select "OPt".
4. Press the "Step" button to leave the setting menu.
Basic settings can be changed.
1. Press the "START STOP" button.
Left display flashes the basic setting parameter (see "Unit and
connection data").
"OPt" appears on the centre display.
The right display shows the first set value.
2. Turn the left knob.
Set number.
3. Press the "START STOP" button.
The basic setting can be adjusted.
4. Turn the right rotary knob.
Set new value.
5. Press the "START STOP" button.
Accept changes.
6. Press the "STEP" button twice to leave the Settings menu without
changes.
7. Press and hold the "STEP" button for 3 seconds.
Changes are saved.
"OPt" flashes on the left display.
The centre display shows "Stor".
The unit restarts.
8. Fill out the start-up operation report.
Installation instructions
Connecting the unit
41