Table of Contents
Advertisement
Installing the unit
Prerequisite Floor capable of accommodating the weight of the unit
5.6.3 Units with casters: Fasten both caster stops to the floor
Prerequisite Floor capable of accommodating the weight of the unit
30
7. Ensure that a tight seal against the floor has been reestablished
after the fastening screws are installed.
8. Complete the start-up operation report.
Floor with steam barrier
In the case of floors with a steam barrier, the floor plates are not
screwed to the floor but fastened with the enclosed adhesive.
Floor must be clean and suitable for the manner fastening
Unit set up and aligned in accordance with the planning drawing
1. Align the floor plates in position 1-1 or 2-2 on the unit leg as
shown in the drawing and mark the floor.
2. Using the adhesive provided, fasten the floor plates to the floor.
Follow the manufacturer's instructions regarding the adhesive.
Apply the adhesive in accordance with the manufacturer's
instructions.
Observe the drying time specified in the manufacturer's
instructions.
3. Complete the start-up operation report.
Floor must be clean and suitable for the manner fastening
1. Place the unit in the intended position.
2. Place roller stops on the rear casters.
3. Mark the position of the caster stops on the floor.
4. Remove the unit.
5. Fix the caster stops to the floor using the appropriate material for
the floor in question.
6. Observe the manufacturer's specifications for the fastening
material.
Installation instructions
Advertisement
Table of Contents
