Table of Contents
Advertisement
Installation and Operation Guide Version E-Box INTELLIPOOL - Programming
12. Use
and
to set the conductivity low alarm value
13. Press
to validate the conductivity low alarm value.
14. Press
to select the conductivity high alarm.
15. Press
to select the conductivity value
16. Use
and
to set the conductivity high alarm value
17. Validate the selection
18. Press
to select the RedOx low alarm.
19. Press
to select the RedOx value
20. Use
and
to set the RedOx low alarm value
21. Press
to validate the RedOx low alarm value.
22. Press
to select the RedOx high alarm.
23. Press
to select the RedOx value
24. Use
and
to set the RedOx high alarm value
25. Validate the selection
26. Return the switch to the ON mode (rear side of the Inner Display).
5.2.6.2
Calibration mode
Despite the calibration of the measurement sensors, it is possible that a value is offset with
another measurement reference frame (usual thermometer, etc.). For this, you have the
possibility to voluntarily correct certain values.
74 / 102
to validate the high conductivity alarm value.
.
.
to validate the RedOx high alarm value.
.
.
.
.
.
Ref. SB-CU-IMP-058EBA / A - 11.05.2023
Advertisement
Table of Contents
