Table of Contents
Advertisement
1. Place the switch in alarm mode (rear side of the Inner Display).
ð Alarm mode is selected on the Inner Display:
2. Press
to select the pH low alarm.
3. Press
to select the pH value
4. Use
and
to set the pH low alarm value
5. Press
to validate the pH low alarm value.
6. Press
to select the pH high alarm.
7. Press
to select the pH value
8. Use
and
to set the pH high alarm value
9. Validate the selection
10. Press
to select the low conductivity alarm.
11. Press
to select the conductivity value
Ref. SB-CU-IMP-058EBA / A - 11.05.2023
Installation and Operation Guide Version E-Box INTELLIPOOL - Programming
calib
.
.
to validate the pH high alarm value.
alarm
on
.
.
.
73 / 102
Advertisement
Table of Contents
