Ph Trend - Pentair E-Box INTELLIPOOL Installation And Operation Manual

Installation and Operation Guide Version E-Box INTELLIPOOL - Programming
The water temperature is 0.5°C
5.2.3

pH trend

1. pH trend (update every 2h)
2. The pH has reached alarm
value
3. Measured pH value
4. Alarm setpoint
compliance
The pH is a quantity (without units) measuring the acidity (0 to 7) or alkalinity (7 to 14) of the basin.
The pH is the concentration of hydrogen ions. For a swimming pool, the ideal pH generally
recommended is close to 7.3 (to be confirmed with your pool owner depending on your
installation).
Tip
The accuracy of the pH measurement is related to the regular maintenance of the pH
probe. It is advisable to check it regularly for any contamination (see Cleaning the pH or
RedOx probe [
mode [ → Page 75]).
68 / 102
The gel pictogram related to the air temperature is displayed
if the temperature measured by the Radio Relay is less than
+3°C.
1
• the pH rises
• the pH is stable
• the pH drops
•
(factory pre-set at 6.7 can be modified through the alarm
menu, see Alarm mode [
•
(factory pre-set at 7.9 can be modified through the alarm
menu, see Alarm mode [
• Limited display between 0 and 9.9
• Display out-of-limit value:
–
–
•
(factory pre-set from 6.7 to 7.9)
•
("min" and "max" indicate if the value is too low or too
high)
→ Page 87] and to calibrate it before the summer season (see Calibration
2 3 4
the pH has reached the maximum alarm value
→
the pH has reached the minimum alarm value
→
pH < 0
pH > 9.9
pH according to alarm setpoints
pH outside the alarm setpoint values
Ref. SB-CU-IMP-058EBA / A - 11.05.2023
Page 72])
Page 72])