Table of Contents
Advertisement
Steps
Note
This function is only supported by certain models.
1. Click to show the PTZ control panel, and click
2. Select one pattern scan path that needs to be set.
3. Click
to start recording pattern scan.
4. Click PTZ control buttons as demands.
Note
Recording stops when the space for pattern scan is 0%.
5. Click
to complete one pattern scan path settings.
6. Click
to call pattern scan.
Stop pattern scan.
Reset pattern scan path.
Delete the selected pattern scan.
Note
If you need to delete all the pattern scans, go to Configuration → PTZ → Clear Config , and
check Clear All Patterns, and click Save.
3.5 Set Limit
The device can only move within the limited range.
Steps
1. Go to Configuration → PTZ → Limit .
2. Select Limit Type.
Manual Stops
It refers to the movement range limit when you control the device manually.
Scan Stops
It refers to the movement range limit when the device scans automatically.
Note
Scan limit is only supported by the device that has scan function.
3. Click Set and set limits according to the prompt on the live image.
4. Optional: Click Clear to clear the limit settings of the selected mode.
5. Click Save.
6. Check Enable Limit.
Network Speed Dome User Manual
.
12
Advertisement
Table of Contents
