Function/Arbitrary Waveform Generator; To Output Basic Waveforms; To Output Sine; Figure 14.1 Afg Setting Menu - Rigol DHO924S User Manual

DHO914S and DHO924S only)
14
14.1
14.1.1
DHO900 User Guide
1.888.610.7664
170
Function/Arbitrary Waveform Generator (for
DHO914S and DHO924S only)
The DHO914S and DHO924S series have a standard built-in 25 MHz Function/
Arbitrary Waveform Generator (AFG), which integrates the signal source and the
oscilloscope into one, providing great convenience for engineers who need to use the
signal source and oscilloscope at the same time. This chapter introduces how to use
the built-in AFG.

To Output Basic Waveforms

Press the front-panel
screen to enable the AFG output. Press the
again to enter the AFG setting menu, as shown in the figure below.
The built-in Function/Arbitrary Waveform Generator can output a variety of basic
waveforms, including Sine, Square, Ramp, DC, Noise, and Arb. You can set the basic
waveform parameters according to the following section and then click or tap the
Output on/off switch to enable/disable the output of the [AFG OUT] connector on
the rear panel.

To Output Sine

In the AFG setting menu as shown in
down button to select "Sine". At this time, you can set the parameters for the sine
waveform.
www.calcert.com
15
10 20
5 25
0 30
key or click or tap the AFG label at the bottom of the
key or click or tap the AFG label

Figure 14.1 AFG Setting Menu

Figure 14.1
, click or tap the Function drop-
Copyright ©RIGOL TECHNOLOGIES CO., LTD. All rights reserved.
sales@calcert.com