To Output Dc; To Output The Arbitrary Waveform; Modulation - Rigol DHO924S User Manual

14.1.5
14.1.6
14.2
Copyright ©RIGOL TECHNOLOGIES CO., LTD. All rights reserved.
1.888.610.7664
Set the Amplitude
Click or tap the Amplitude input field to set the amplitude with the pop-up numeric
keypad. You can also use the corresponding multipurpose knob to set the value. Its
range is from 2 mV to 10 V.
Set the Offset
Click or tap the Offset input field to set the offset with the pop-up numeric keypad.
You can also use the corresponding multipurpose knob to set the value. The offset
range is related to the amplitude value.

To Output DC

In the AFG setting menu as shown in
down button to select "DC". At this time, you can set the offset for DC.
Click or tap the Offset input field to set the offset with the pop-up numeric keypad.
You can also use the corresponding multipurpose knob to set the value. Its range is
from -5 V to 5 V.

To Output the Arbitrary Waveform

In the AFG setting menu as shown in
down button to select "Arb". At this time, you can load the arbitrary waveform and
set the parameters. For how to set the frequency, phase, amplitude, and offset, refer
To Output Sine
to descriptions in
arbitrary waveform.
Click or tap the input field of Arb Path, and then the disk management interface is
displayed. In the disk management interface, select the waveform from the internal
memory or the external memory. The waveform file is suffixed with "*.arb". Then click
or tap OK to load the selected waveform. For details, refer to

Modulation

The built-in Function/Arbitrary Waveform Generator of DHO914S and DHO924S
supports amplitude modulation (AM), frequency modulation (FM), and phase
modulation (PM). A modulated waveform consists of a carrier waveform and a
modulating waveform. The carrier waveform is the basic waveform output from the
Function/Arbitrary Waveform Generator, and the modulating waveform can be the
built-in waveform.
In the AFG setting menu, click or tap the Modulation tab to enter the Modulation
setting menu, as shown in the figure below. In this menu, you can select the
modulation type, set the modulating waveform parameters, and enable/disable the
modulation function. To set the carrier waveform (basic waveform), refer to
Basic Waveforms
. This section only illustrates the modulation setting.
www.calcert.com
15
10 20
5 25
0 30
DHO914S and DHO924S only)
Figure 14.1
, click or tap the Function drop-
Figure 14.1
, click or tap the Function drop-
. This section only illustrates how to load the
Store and Load
.
To Output
DHO900 User Guide
sales@calcert.com
173