Can Decoding; Figure 18.15 Can Decoding Menu - Rigol DHO924S User Manual

18.6
DHO900 User Guide
1.888.610.7664
214
Export
When the oscilloscope is in "STOP" state, you can export the time and its
corresponding decoded data in the event table.
In Decode menu, click or tap Export, then the save setting interface is displayed. You
can export the data to the internal memory or the external USB storage device (only
when detected) in *.csv format. For details, refer to
Interpret the Decoded LIN Data
• Break (Sync Break): expressed in Hex, identified as "Break:".
• SYNC (Sync): expressed in Hex, identified as "SYNC:".
• ID (Frame ID): expressed in Hex, identified as "ID:".
• Data (Data): Its display format is the same as that of the bus data (Hex, Dec, Bin,
or ASCII), identified as "Data:".
• Checksum (check sum): expressed in Hex, identified as "Checksum:". When errors
occur, it is displayed as a red patch.
• Wakeup (wake up symbol): identified as "Wakeup:".

CAN Decoding

The oscilloscope samples the CAN signal at the specified sample position, and judges
each data point to be logic "1" or logic "0" according to the preset threshold level.
You need to specify the CAN signal type and sample position.
In the Decode menu, click or tap the drop-down button of Bus Type to select CAN,
then configure the parameters for CAN decoding.
www.calcert.com
15
10 20
5 25
0 30

Figure 18.15 CAN Decoding Menu

Copyright ©RIGOL TECHNOLOGIES CO., LTD. All rights reserved.
Store and Load
.
sales@calcert.com