18.5.2
18.5.3
Copyright ©RIGOL TECHNOLOGIES CO., LTD. All rights reserved.
1.888.610.7664
•
In Version, select the protocol version that matches the LIN bus signal. The
available versions include "1.X", "2.X", and "Both".
Display-related Settings
In Decode menu, set the following display-related parameters.
Set the Display Format
Click or tap the drop-down button of Format to select the display format of the bus
data and event table. The available options include "Hex", "Dec", "Bin", and "ASCII".
Set the Label Display
Click or tap the Label on/off switch to enable or disable the label display of the
decoding bus. When enabled, the bus label will be displayed at the upper-left side of
the bus (when the bus display is enabled). The label shows the current bus type.
Event Table
Open or Close the Event Table
Click or tap the Event Table on/off switch to enable or disable the display of the
event table. When enabled, the event table is displayed as shown in the figure below.
You can also click or tap the icon
the event table.
Line No.
Time
Figure 18.14 LIN Decoding Event Table
TIP
•
When you adjust the horizontal time base, the waveform displayed on the screen will also
change, and the total number of lines containing the decoding information in the event
table will also be changed.
•
The displayed decoded data information in the bus is related to the value of the
horizontal time base. Reducing the horizontal time base can help you view the detailed
information.
www.calcert.com
15
10
20
5
25
0
30
at the upper-right corner of the table to close
Frame ID
Decoded Data
LIN Bus
Checksum
Error
DHO900 User Guide
sales@calcert.com
213