Accelerator Cable - Club Car Carryall 300 2018 Maintenance And Service Manual

23
Engine Control Linkages
5. Adjust governor cable jam nuts until throttle lever (2) is at "wide open throttle" (WOT) (Figure 23-7, Page 23-8)
and tighten the governor cable jam nuts to 36 in·lb (4.0 N·m).
6. Release governor arm (4) to return to "idle" position.
7. Adjust gap (A) between governor arm (4) and throttle stop screw (7) to 0.055 in. (±0.039) (1.4 mm (±1)) as shown
(Figure 23-9, Page 23-9). Tighten stop screw jam nut (6) to 36 in·lb (4.0 N·m).
8. Check engine RPM adjustment. See Engine RPM Adjustment on page 23-12.

ACCELERATOR CABLE

Accelerator Cable Removal
1. Turn the key switch to the OFF position and remove the key, place the Forward/Reverse handle in the NEUTRAL
position, and chock the wheels.
2. Disconnect battery and spark plug wire(s). See Disconnecting the Battery- Gasoline Vehicles on page 1-3.
3. At transaxle:
3.1. Unhook spring fitting of accelerator cable (8) from governor arm (4) (Figure 23-8, Page 23-9).
3.2. Unsnap accelerator cable (8) from FNR/accelerator cable bracket (9).
4. At electrical component box:
4.1. Remove electrical component box cover and loosen jam nuts (10) on side of electrical component box
(Figure 23-10, Page 23-10).
4.2. Disconnect barrel fitting (11) of accelerator cable (8) from cam (12) in electrical component box and remove
accelerator cable (8) from vehicle.
11
10
3046
Figure 23-10 Accelerator Cable At Electrical Component
Accelerator Cable Installation
1. At transaxle:
1.1. Hook spring fitting of accelerator cable (8) to governor arm (4) (Figure 23-8, Page 23-9).
1.2. Snap accelerator cable (8) into FNR/accelerator cable bracket (9).
1.3. Push dust shield (13) onto end of cable housing.
2. At electrical component box:
2.1. Insert barrel fitting (11) of accelerator cable (8) into cam (12) in electrical component box (Figure 23-10,
Page 23-10).
Page 23-10 2018 Carryall 300 Maintenance and Service Manual
12
Box
FUEL SYSTEM: GASOLINE VEHICLES