Table of Contents
Advertisement
Chapter 2 Front Panel Operations
outputs the inverted signal of the output signal of CH1 (if channels are currently
enabled).
Off: disables the track function. This is the default state.
⚫
Note:
When the track function is enabled, the coupling function is disabled.
Waveform Combination
1. To Enable the Waveform Combination Function
In the channel setting interface, tap the CombineSet menu label and then tap
the Combine parameter selection field to select "On" to enable the waveform
combine function. Then, you can combine the specified waveforms based on the
current fundamental waveform. If you select "Off", the waveform combine
function is disabled.
Note:
This function is only valid for the basic waveforms.
2. To Select the Waveform to be Combined
In the channel setting interface, tap the CombineSet menu label and then tap
the Waveform parameter selection field to select a waveform to be combined
to the current basic waveform.
3. Freq Combination
Sets the frequency of the waveform to be combined to the current basic
waveform. In the channel setting interface, tap the CombineSet menu label
and then tap the Freq parameter input field to input the desired value by using
the numeric keypad. The range is related to the currently selected basic
waveform.
4. Ratio
Sets the ratio of the amplitude of the waveform to be combined to that of the
current basic waveform. In the channel setting interface, tap the CombineSet
menu label and then tap the Ratio parameter input field to input the desired
value by using the numeric keypad.
DG2000 User Guide
RIGOL
2-89
Advertisement
Table of Contents
