Table of Contents
Advertisement
RIGOL
input interface. If other characters are used to name the file, the name might not be
normally displayed in the store and recall interface.
File Type
The file types supported by DG2000 include State File, Arb File, Csv File, and Bmp
File.
1. State File
Stores the instrument state in the internal or external memory in "*.RSF" format.
The state file stored includes the dual-channel selected waveform, frequency,
amplitude, offset, duty cycle, symmetry, phase, modulation, sweep, burst
parameters, frequency counter parameters, as well as utility function parameters
and system parameters under the Utility menu.
2. Arb File
Stores the user-defined arbitrary waveform in the internal or external memory in
"*.RAF" format.
For the arbitrary waveform file, the voltage values corresponding to each
waveform point are stored in binary data format. The voltage value at each point
takes up 2 bytes (16 bits). Therefore, its format of the binary data is from 0x0000
to 0xFFFF.
The stored arbitrary waveform files can be read by the DG2000 series. Besides,
the arbitrary waveform files stored in the USB storage device can be opened and
edited by data editing tools (e.g. WinHex or UltraEdit) on the PC.
3. Csv File
Reads the data file in Csv format from the external memory. After finishing
reading the file, the instrument automatically enters the arb waveform function
interface. The arbitrary waveforms that have been read are stored in the RAM.
4. Bmp File
Reads the "*BMP" format bitmap file from the external memory. It is only
available when you self-define splash screen.
Categories
In the Store and Recall interface, tap the "Arb File" or "State File" under the
Categories menu label to view the arb file or state file in the first-level folder of Disk
C and D (when inserted with a USB storage device).
2-74
Chapter 2 Front Panel Operations
DG2000 User Guide
Advertisement
Table of Contents
