Chapter 2 Front Panel Operations
To Output the Arbitrary Waveform
DG2000 can output built-in waveforms from a single channel or from two channels at
the same time. The 160 kinds of built-in arbitrary waveforms are stored in the
internal non-volatile memory.
To Enable Arbitrary Waveforms
Press the Shift key and its backlight turns on. Then press Home/Menu →
Continuous → "Arb" to enable arbitrary waveform function and open the arbitrary
waveform selection interface, as shown in the figure below. When the Shift key is
not illuminated, you can directly press Arb/Help/Local to enable arbitrary
waveform function.
Figure 2-4 Arbitrary Waveform Selection Interface
To Select the Waveform
DG2000 allows users to select 160 built-in waveforms and arbitrary waveforms
stored in the internal or external memory of the instrument.
Key Points:
After selecting the desired waveform, press the corresponding channel output
control key (Output1 or Output2), and the specified waveform will be output
from the channel. For details, refer to descriptions in "To Enable Channel
Output". Note that when the frequency of the arbitrary waveforms is greater than
1 MHz, some waveforms will be distorted.
DG2000 User Guide
RIGOL
2-17