Table of Contents
Advertisement
Chapter 2 Front Panel Operations
Store and Recall
DG2000 can store the current instrument state and user-defined Sequence
waveforms in the internal or external memory. You can recall them when needed.
DG2000 can also seamlessly interconnect with RIGOL's oscilloscopes that support
USB-TMC; rebuild and output the waveform data collected by the oscilloscope
losslessly.
When the Shift key is illuminated, press Noise/Store on the front panel or tap the
icon in the information setting area at the lower-right corner of the user interface
to enable the Store/Recall function and open the Store/Recall interface as shown in
the figure below.
Storage System
DG2000 can store the current instrument state and user-defined Sequence
waveforms in the internal or external memory. You can recall them when needed.
DG2000 provides an internal non-volatile memory (Disk C) and an external memory
(Disk D).
1． Disk C: You can store instrument states and Sequence waveform files (created
by users or downloaded through remote commands) to Disk C. Also, you can
copy the files from Disk C to the USB storage device.
2． Disk D: available when the USB storage device is detected by the rear-panel
USB HOST interface.
You can store state files or arbitrary waveform files to Disk D. The number of the
files that can be stored is determined by the storage capacity of the USB storage
device.
The Csv files and Bmp files stored in the USB storage device can also be read.
Note:
DG2000 can only identify the file whose filename is named in the filename
DG2000 User Guide
Figure 2-18 Store and Recall Interface
RIGOL
2-73
Advertisement
Table of Contents
