Example: To Output Sine - Rigol DG2052 User Manual

Chapter 2 Front Panel Operations

Example: To Output Sine

This section mainly introduces how to output Sine waveforms (frequency 20 kHz,
amplitude 2.5 Vpp, offset 500 mV
1. Select the output channel: Press Output1 on the front panel or tap the
channel output configuration status bar
the channel is indicated in red in the status bar.
2. Select Sine waveforms: Press the Shift key and its backlight turns on. Then
press Home/Menu on the front panel, and then the waveform selection
interface is displayed. Tap Continuous and then select the "Sine" icon to go to
the sine waveform parameter setting interface automatically. When the Shift
key is not illuminated, you can also press Sine/Preset to go to the sine
waveform parameter setting interface.
3. Set frequency: Tap the Freq parameter input field to input 20 with the pop-up
numeric keypad, and then select the unit "kHz". Tap "Ok".
4. Set amplitude: Tap the Ampl parameter input field to input 2.5 with the
pop-up numeric keypad, and then select "Vpp" as the unit. Tap "Ok".
5. Set offset voltage: Tap the Offset parameter input field to input 500 with the
pop-up numeric keypad, and then select "mVdc" as the unit. Tap "Ok".
6. Set start phase: Tap the Phase parameter input field to input 90 with the
pop-up numeric keypad, and then select "°" as the unit. Tap "Ok".
7. Enable channel output: Press Output1 and the backlight turns on. Also, you
can tap the channel output configuration status bar
channel output. Then, the channel status is highlighted (i.g.
the Sine signal is output from the [CH1] connector based on the current
configurations.
8. Observe the output waveform: Connect the [CH1] connector of DG2000 to
the oscilloscope by using the BNC cable. The waveform is as shown in the figure
below.
DG2000 User Guide
, start phase 90°) from the [CH1] connector.
dc
to select CH1. At this time,
to enable the
RIGOL
), and
2-15