Table of Contents
Advertisement
Chapter 1 Quick Guide
User Interface
The DG2000 user interface is shown in the following figure.
8
9
10
11
1
1. Channel Output Configuration Status Bar
Displays the current output configuration of the channel.
Note:
Two channels can be enabled simultaneously, but you cannot select both
channels at the same time.
DG2000 User Guide
Figure 1-1 User Interface
Selected Waveform:
Sine/Square/Ramp/Pulse/Noise/Prbs/Dualtone/Harm
/Rs232/DC/Arb/Sequence
Modulation Type:
Sweep Type:
Linear/Log/Step
Burst Type:
Ncycle/Infinite/Gated
Channel Output State:
ON: illuminated in yellow.
OFF: grayed out.
7
6
2
AM/FM/PM/ASK/FSK/PSK/PWM
Output Impedance Type:
High impedance: displays HighZ.
Load: displays impedance (the
default is 50 Ω and the range is
from 1 Ω to 10 kΩ).
RIGOL
5
4
3
1-13
Advertisement
Table of Contents
