Chapter 2 Front Panel Operations
then use the numeric keypad to set the GPIB address to any value ranging from 0 to
30. The default is "2". The selected address is stored in the non-volatile memory.
To Set the LAN Parameters
When the Shift key is illuminated, press Pulse/Utility → Interface → LAN to
open the LAN parameters configuration interface as shown in the figure below. You
can view the network status and configure the network parameters.
Network Status
Different prompt messages will be displayed based on the current network status.
Connected: indicates that the network connection is successful.
⚫
Disconnect: indicates that the network connection is failed.
⚫
Adapter not found: indicates that the network is not connected.
⚫
IP Configuration
IP configuration mode can be DHCP, AutoIP, or ManualIP. In different IP
configuration modes, the configurations for the IP address and other network
parameters are different.
1. DHCP
In DHCP mode, the DHCP server in the current network assigns the network
⚫
parameters (e.g. IP address) for the signal generator.
Tap the DHCP parameter selection field to select "On" or "Off" to turn
⚫
DHCP mode on or off.
2. AutoIP
DG2000 User Guide
Figure 2-26 LAN Setting Interface
RIGOL
2-93