Chapter 2 Front Panel Operations
RIGOL
DC
DG2000 can output DC signal with amplitude range from -10 V to 10 V (HighZ) or
from -5 V to 5 V (when the load is 50 Ω). The figure below shows a sketch of the DC
signal. When the Shift key is illuminated, press Home/Menu → Continuous →
"DC" to select the DC signal.
Figure 2-6 Sketch of DC signal
Tap the Offset parameter input field to input the desired offset value with the
numeric keypad, then select the unit. Tap "Ok".
You can also use the arrow keys and the knob to set the parameter value: press
down the knob to enter the editing mode, use the arrow keys to move the cursor to
select the digit to be edited, and then rotate the knob to modify the value.
2-28
DG2000 User Guide