Table of Contents
Advertisement
Chapter 2 Front Panel Operations
RIGOL
Decimal Point
When the Shift key is illuminated, press Pulse/Utility → System Setting →
Decimal to set the display format of the decimal point in the number parameter. It
can be set to a decimal "." or a comma ",". By default, it is a decimal ".". This setting
is stored in non-volatile memory and will not be affected by the "restore to defaults"
operation.
Delimiter
When the Shift key is illuminated, press Pulse/Utility → System Setting →
Delimiter to set the display format of the delimiter in the number parameter. This
setting is stored in non-volatile memory and will not be affected by the "restore to
defaults" operation.
When the decimal is set to ".", the delimiter can be set to "," "Space", or "None";
when the decimal point is set to ",", the delimiter can be set to ".", "Space", or
"None". The decimal point and the delimiter cannot be set to a decimal "." or a
comma "," at the same time.
System Log
Enables or disables the system log function. When enabled, the keys and prompt
messages can be recorded, and they will be saved to the internal memory in
Syslog.log file format.
When the Shift key is illuminated, press Pulse/Utility → System Setting →
System Log to select "On" or "Off". The default is "Off".
Interface
When the Shift key is illuminated, press Pulse/Utility → Interface to select a
different interface type. You can set the GPIB address, LAN interface parameters, or
select the type of the device connected to the USB interface. The interface selection
is stored in the non-volatile memory.
To Set the GPIB Address
Each device connected to GPIB interface must have a unique address.
When the Shift key is illuminated, press Pulse/Utility → Interface → GPIB, and
2-92
DG2000 User Guide
Advertisement
Table of Contents
