Chapter 2 Front Panel Operations
RIGOL
To Enable Channel Output
After configuring the parameters of the waveform selected, enable the channel to
output the waveforms.
Before enabling channel output, you can also tap
or
and
then tap the corresponding menu label in the channel setting interface to set the
parameters related with the channel output. For details, refer to descriptions in
"Channel Setting".
Press Output1 or Output2 on the front panel, and then the backlight turns on. You
can also tap the channel output configuration status bar
or
enable the channel output in the channel setting interface. When the channel status
bar is highlighted, (i.g.
or
), the configured waveforms are
output from the corresponding output connector on the front panel.
DG2000 User Guide
2-13