RIGOL
System Utility Function
To Restore Preset
When the Shift key is illuminated, press Sine/Preset to restore the preset status
interface, as shown in the figure below.
Factory: Tap the Def icon, then a dialog box is displayed, tap "Apply" to restore
⚫
the system to its factory defaults.
User save: Tap any one of the items from "User1" to "User10". Then a dialog
⚫
box is displayed. Tap "Save" to save the current system status to the internal
non-volatile memory as user-defined settings. To use the state again, tap the
icon (any one of the items from "User1" to "User10") to quickly recall the
setting. You can store up to 10 system states.
The defaults are shown in the following table. Note that the item with "*" is the
factory default value, and its value is related to the user setting during its usage but
not affected by the factory default restore operation.
Table 2-4 Factory Defaults
Parameter
Channel Parameter
Current Carrier Waveform
Output Impedance
Output Load
Channel Output
Output Inverted
Level Limit
HighL Limit
LowL Limit
SyncState
2-98
Figure 2-27 Preset Status Restore Interface
Chapter 2 Front Panel Operations
Factory Settings
Sine
HighZ
50 Ω
Off
Off
Off
0 V
0 V
Off
DG2000 User Guide