Connecting a video source using DVI
The Dual Link DVI input card (DDIC) accepts digital video source from DVI sources. It does not
support incoming analog signals.
Enables connection of one DVI cable to the DVI input of a DDIC card (in any slot). In this
configuration, the DVI input supplies the entire video raster.
Connecting a video source using HDBaseT
The HDBaseT port on the IMXB accepts digital video data from HDBaseT sources.
Enables connection of one Ethernet cable to the HDBaseT port on the IMXB. The HDBaseT input
supplies the entire video raster.
Selecting a video source
After connecting a video source to the projector and making sure your port configuration is correct,
you must select it.
1. From the side panel home page, select INPUT.
2. Navigate the list of input selections until you find a selection that best matches your
configuration.
3. To select the input, select Enter.
Connecting to a computer or server
Communicate with a remote computer, server, or an existing network using a RJ-45 cable.
The RS232 port located on the IMXB faceplate uses Christie-proprietary protocol and is intended for
Christie accessories or automation controllers only.
For more information, on the serial commands, see the Boxer 30 Serial API Commands Technical
Reference (P/N: 020-102096-XX).
1. Use an RJ-45 cable to connect the Ethernet hub or switch to the Ethernet port, located on the
projector IMXB faceplate.
2. When using the Christie serial protocol over Ethernet, connect to port 3002.
3. For applications or equipment using serial communications, use the Christie-proprietary serial
protocol to communicate with the RS232 port on the IMXB faceplate.
Boxer 30 Installation and Setup Manual
020-102017-01 Rev. 1 (11-2015)
Connecting devices and establishing communication
32