Configuring Communications; Enabling Projector Communication; Setting The Remote Access Level - Christie Mirage HD25 User Manual

Configuring
communications
Defines and controls how single or multiple projectors are linked with each other and with a controlling
device.

Enabling projector communication

Enable the receivers and the wired keypad to communicate with the projector from the remote.
The front and rear IR sensors receive transmissions from the IR remote. Keep the transmission path to
these sensors unobstructed for uninterrupted communications with the projector.
Alternatively, you can connect a wired version of the remote to the connector on the IMXB labeled
Wired Keypad.
1. Select MENU > Communications > Projector Communications.
2. To assign the projector an ID, select Projector ID.
3. Use the up and down keys to enter the projector ID.
4. Select Enter.
5. To enable the front IR sensor, select Front IR Enabled and select Enter.
6. To enable the rear IR sensor, select Rear IR Enabled and select Enter.
7. To enable a wired version of the remote, select Wired Keypad Enabled and select Enter.
By default this feature is enabled.
8. To enable HD control for video signals, Ethernet, or IR, select HDBaseT IR Extender Enabled
and select Enter.

Setting the remote access level

Determine if and how the projector can be accessed remotely for the RS232 port or the Ethernet.
1. From the display panel, select MENU > Admin > Service.
2. Enter the service password.
3. To determine the remote access for the Ethernet port, select Remote Access Level
(Ethernet).
4. Select the appropriate remote access level:
• No Access
• Login Required
• Free Access
5. Select Enter.
Crimson User Guide–Mirage HD25, Mirage WU25, Crimson HD25, Crimson WU25
020-102649-01 Rev. 1 (04-2018)
Copyright 2018 Christie Digital Systems USA, Inc. All rights reserved.
©
38