Configuring Communications; Enabling Projector Communication; Setting The Remote Access Level - Christie Mirage SST User Manual

Hide thumbs Also See for Mirage SST:

Table of Contents

Configuring

communications

Defines and controls how single or multiple projectors are linked with each other and with a controlling

device.

Enable the receivers and the wired keypad to communicate with the projector from the remote.

The front and rear IR sensors receive transmissions from the IR remote. Keep the transmission path to

these sensors unobstructed for uninterrupted communications with the projector.

Alternatively, you can connect a wired version of the remote to the connector on the IMXB labeled

Wired Keypad.

1. Select MENU > Communications > Projector Communications.

2. To assign the projector an ID, select Projector ID.

3. Use the up and down keys to enter the projector ID.

4. Select Enter.

5. To enable the rear IR sensor, select Rear IR Enabled and select Enter.

6. To enable a wired version of the remote, select Wired Keypad Enabled and select Enter.

By default this feature is enabled.

Determine if and how the projector can be accessed remotely for the RS232 port or the Ethernet.

1. From the display panel, select MENU > Admin > Service.

2. Enter the service password.

3. To determine the remote access for the Ethernet port, select Remote Access Level

(Ethernet).

4. Select the appropriate remote access level:

•

No Access

•

Free Access

5. Select Enter.

6. To determine the remote access for the RS232 IN port, select Remote Access Level (RS232

IN).

7. Select the appropriate remote access level:

Mirage SST User Guide

020-102993-01 Rev. 1 (06-2019)

Table of Contents