Set Device Position - HIKVISION DS-2SF8C442MXG-EL/26 User Manual

Note
More calibration points may increase calibration accuracy, but more focusing time is required.
The default amount is recommended.
3. Select the scene to display the calibration line.
A red line displays on live image.
4. Adjust the length and position of the line by dragging its two endpoints.
Note
The red line is recommended to stay in the center of the scene and to cover ground at the same
time.
Double click the image to enter full screen mode.
5. Click Start Calibration.
Calibration status displays on the live image.
6. Repeat to add other scenes and complete the calibration.
7. Check Enable Height Compensation if the mounting height of the device is lower than 3 meters.
8. Check Enable after successful calibration.
9. Click Save.

4.14 Set Device Position

Before You Start
Go to Configuration → PTZ → Basic Settings → PTZ OSD to enable PT Status display.
Use other direction indicating devices to find the North at the device location.
Steps
1. Go to Configuration → PTZ → Position Settings .
2. Set compass.
1) Adjust the tilt position of the device to 0 by controlling the up arrow and down arrow on the
PTZ panel.
2) Adjust the pan position to show the live view of the north direction by controlling the left
arrow and right arrow on the PTZ panel.
3) Click Set as North.
3. Click Gyroscope Attitude Calibration to calibrate gyroscope.
Note
Only the device with built-in gyroscope supports this function.
4. Get the device location information in advance, and input the longitude and latitude of the
device manually.
5. Set vandal-proof alarm.
The function enables the device to trigger alarms when its position changes because of shock or
vandalism.
TandemVu PTZ Camera User Manual
53