Table of Contents
Advertisement
4.10 Set Device Position
Before You Start
Go to Configuration → PTZ → Basic Settings → PTZ OSD to enable PT Status display.
Steps
1. Go to Configuration → PTZ → Position Settings .
2. Select a PT Mode.
Manual Use a direction indicating device to determine the North at the device location, and
set the North for the device. For details, see Set Manual Compass .
Auto
For the device that has built-in e-compass, the compass can automatically tell the
north direction for the device. For details, see Set Auto Compass .
3. Click Gyroscope Attitude Calibration to calibrate gyroscope.
Note
Only devices with built-in gyroscope support this function.
4. Set vandal-proof alarm.
After enabling the function, the device triggers alarms when its position changes because of
shock or vandalism.
Sensitivity
The higher the value is, the easier the alarm will be triggered.
Upload Vandal-proof Alarm
The device uploads the alarm information when the alarm is triggered.
Vandal-proof Alarm Voice Warning
The camera triggers the alarm with audible warning.
5. Select a Longitude-Latitude Mode to set the geographic location of the device.
Auto
For device with a built-in positioning module, select Auto to automatically obtain
the longitude and latitude of the device location.
Manual Get the device location information in advance, and input the longitude and
latitude manually.
6. Click Save.
What to do next
If you lose direction when operating the device, you can click Point to North to call the north
position that is saved in the device.
Network Speed Dome User Manual
32
Advertisement
Table of Contents
