Set Privacy Mask; Set Device Position - HIKVISION DS-2TD8166-150ZH2F/V2 User Manual

Thermal & Optical Bi-spectrum PTZ Network Camera User Manual

9.10 Set Privacy Mask

Privacy mask enables you to cover certain areas on the live image to prevent certain spots in the
video security area from being live viewed and recorded.
Steps
1. Go to Configuration → PTZ → Privacy Mask.
2. Adjust the live image to the target scene via PTZ control buttons.
3. Draw the area.
Draw Area
Stop Drawing
4. Click Add.
It is listed in Privacy Mask List.
5. Edit Name, Type, and Active Zoom Ratio on your demand.
Active Zoom Ratio
When the actual zoom ratio is less than the set active zoom ratio, the set area can not be
covered. When the actual zoom ratio is greater than the set active zoom ratio, the privacy
mask is valid. The maximum value of active zoom ratio depends on the camera module.
6. Repeat the steps above to set other privacy masks.
7. Check Enable Privacy Masks.

9.11 Set Device Position

Before You Start
Go to Configuration → PTZ → Basic Settings → PTZ OSD to enable PT Status display.
Steps
1. Go to the setting page: Configuration → PTZ → Position Settings.
2. Select a PT Mode.
Manual
Auto
Use a direction indicating device to determine the North at the device
location, and set the North for the device. For details, seeSet Manual
Compass.
For the device that has built-in e-compass, the compass can
automatically tell the north direction for the device. For details,
seeSet Auto Compass.
Click Draw Area, and click on the live view
image to determine the boundary of the
mask.
ClickStop Drawing after drawing the mask.
44