HIKVISION DS-2SF8C442MXG-EL/26 User Manual page 35

What to do next
Set the linkage and alarm. See ITS Linkage and Alarm for details.
Set Illegal Parking Evidence Capture Parameters
Go to VCA → Intell Traffic Event → Advanced Configuration → Advanced to set the parameters.
Illegal Parking LPR Area
Set the size of license plate recognition area that suits the actual situation to avoid mistakenly
recognize the license plate of other vehicles around.
Illegal Parking LPR Double Check
The device double-checks the license plate to avoid mistakenly capturing of other vehicles.
Illegal Parking LPR Grading Threshold
If the confidence level of captured license plate or any character on the license plate is lower
than the threshold, the plate will not be recognized. The alarm information may be filtered out
if the threshold is too high.
Illegal Parking Plate Size Threshold
If the width of the captured license plate is lower than the set threshold, the plate will not be
recognized. The lower the threshold is, the smaller plates will be filtered out. It is recommended
to keep the default value.
Illegal Parking Target Lock
When the illegal parking target lock is enabled, the device focuses on the vehicle that triggers
the evidence capture and ignores other vehicles. It is suitable for situations where strict
enforcement is required, but it decreases the overall evidence capture efficiency.
Set Reverse Driving Detection
Reverse driving refers to driving against the direction of traffic. The device detects violations and
captures evidence pictures.
Before You Start
Set detection scenes and detection areas. See Set Detection Scene and Set Lane Area for details.
Steps
1. Go to VCA → Intell Traffic Event → Common Settings → Speed Dome Rule Settings .
2. Select Enforcement.
3. Click Reverse Driving Detection and check Enable.
4. Select Arm Lane.
Note
The direction of the arm lane cannot be Unknown.
TandemVu PTZ Camera User Manual
23