Set Device Position - HIKVISION DS-2TD6267-75C4L/WY User Manual

Thermal & Optical Bi-spectrum PTZ Network Camera User Manual
Before You Start
Note
This function is only supported by certain models.
Finish setting the desired actions (Linear Scan and Patrol are available) and VCA functions (Fire
Detection is available). See Set Linear Scan , Set Patrol Scan , and Fire and Smoke Detection for
configuration instructions.
Steps
1. Go to Configuration → PTZ → Combined Path .
2. Select a channel.
3. Select a path number from the drop-down list.
Up to 4 paths are available.
4. Click Add, and set the action type, action No. and VCA type for the added action.
Up to 10 actions can be added to one path.
You can click ON to manually call the path and OFF to stop it.
5. Click Save.
What to do next
Set the combined path in park action (see Set Park Action ) or scheduled task (see Set Scheduled
Tasks ).

9.12 Set Device Position

Before You Start
Go to Configuration → PTZ → Basic Settings → PTZ OSD to enable PT Status display.
Steps
1. Go to the setting page: Configuration → PTZ → Position Settings .
2. Select a PT Mode.
Manual Use a direction indicating device to determine the North at the device location, and
set the North for the device. For details, see Set Manual Compass .
Auto For the device that has built-in e-compass, the compass can automatically tell the
north direction for the device. For details, see Set Auto Compass .
3. Optional: Check Display Position Diagram to display the position diagram on the live view.
4. Set Vandal-proof alarm.
After enabling the function, the device triggers alarms once its position changes because of
shock or vandalism.
Sensitivity
The higher the value is, the easier the alarm will be triggered.
Upload Vandal-proof Alarm
54