HIKVISION DS-2SF8C442MXG-EL/26 User Manual page 47

TandemVu PTZ Camera User Manual
Upload by FTP
Upload the data of enforcement, vehicle detection, and traffic data collection to an FTP server.
Before You Start
The FTP server is configured.
Steps
1. Go to VCA → Intell Traffic Event → Advanced Configuration → FTP Host
2. Check Enable FTP.
3. Select a Character Encoding Mode.
4. Enter the IP Address, Port, User Name, and Password of the FTP server.
5. Set the picture names and saving paths of detections.
6. Click Save.
Upload by SDK
Upload the alarm messages by SDK in listening and arming mode.
Go to VCA → Intell Traffic Event → Common Settings → Basic Configuration to set the parameters.
Listening Server
You can upload alarm messages and pictures to a listening server by SDK. Enter the IP Address and
Port of the listening server and click Save.
Note
Make sure that the listening server is enabled with listening service and that the network
connection with the device is normal.
ANR
You can upload alarm messages and pictures to an arming server by SDK. Enter the Arming Host IP
Address and click Save. When the device loses connection with the arming server, the data is saved
in the memory card of the device and will be uploaded again when the connection resumes.
Set Armed License Plates
You can specify the vehicles you want to arm by adding their license plates to the blocklist or
allowlist.
Steps
1. Go to VCA → Intell Traffic Event → Advanced Configuration → Blocklist & Allowlist .
2. Click Export to export license plate list template.
35