HIKVISION DS-2SF8C442MXG-EL/26 User Manual page 37

Before You Start
Set detection scenes and detection areas. See Set Detection Scene and Set Lane Area for details.
Steps
1. Go to VCA → Intell Traffic Event → Common Settings → Speed Dome Rule Settings .
2. Select Enforcement.
3. Click Over Lane Line Detection and check Enable.
4. Select Arm Lane.
Note
If the lane line is Solid-Broken Line or Broken-Solid Line, only driving from the solid side triggers
the alarm.
Over lane line detection takes effect in the selected lane areas.
5. Set the Amount of Pictures.
The device takes evidence pictures of the set amount when a vehicle hits the trigger line in the
detection area.
6. Set Sensitivity.
With higher sensitivity, the device is more sensitive to detect and recognize targets.
7. Click Save.
What to do next
Set the arming schedule, linkage and alarm. See Set ITS Arming Schedule and ITS Linkage and
Alarm for details.
Set Illegal Lane Change Detection
The device detects vehicles changing lanes where it is not allowed and captures evidence pictures.
Before You Start
Set detection scenes and detection areas. See Set Detection Scene , Set Polygon Area and Set Lane
Area for details.
Steps
1. Go to VCA → Intell Traffic Event → Common Settings → Speed Dome Rule Settings .
2. Select Enforcement.
3. Click Illegal Lane Change Detection and check Enable.
4. Select Arm Lane or Arm Polygon.
Note
If the line type is Solid-Broken Line or Broken-Solid Line, only driving from the solid side
●
triggers the alarm.
If you choose Arm Polygon, set and select at least two polygon areas for the detection to take
●
effect.
TandemVu PTZ Camera User Manual
25