Table of Contents
Advertisement
A numbered green cross displayed on the live image.
2) Drag the green cross to a certain position.
3) Repeat the steps above to add more calibration points.
Note
It is recommended to add at least 9 calibration points in one scene. For higher tracking
●
precision, up to 12 calibration points can be added. Calibration points should be distributed
evenly in live image, for example, 3 points at far range, middle range, and close range each.
It is recommended to put calibration points at distinct positions in live image (for example,
●
corners). If no distinct position is available, you can place something (for example, box, stool,
or people) to mark the position.
5. Link the PTZ channel to the calibration points in panorama view.
1) Select a calibration point in panorama view.
2) Adjust the PTZ channel to set the center of the close-up view at the same position as the
calibration point in panorama view by using the PTZ control buttons or by clicking
clicking or dragging an area on live image.
3) Click
to link the current PTZ positions to the calibration point.
4) Repeat the steps above to link other calibration points.
6. Click Start Calibration to finish the calibration for the current scene.
7. When calibration is complete, click Stop Calibration to exit.
8. Click Save.
4.12 Set Device Position
Before You Start
Go to Configuration → PTZ → Basic Settings → PTZ OSD to enable PT Status display.
Use other direction indicating devices to find the North at the device location.
Steps
1. Go to Configuration → PTZ → Position Settings .
2. Set compass.
1) Adjust the tilt position of the device to 0 by controlling the up arrow and down arrow on the
PTZ panel.
2) Adjust the pan position to show the live view of the north direction by controlling the left
arrow and right arrow on the PTZ panel.
3) Click Set as North.
3. Click Gyroscope Attitude Calibration to calibrate gyroscope.
Note
Only the device with built-in gyroscope supports this function.
4. Get the device location information in advance, and input the longitude and latitude of the
device manually.
5. Set vandal-proof alarm.
Stitched PanoVu Camera with PTZ User Manual
24
and then
Advertisement
Table of Contents
