HIKVISION DS-2SF8C442MXG-EL/26 User Manual page 31

7. Click Save.
Set Polygon Area
A polygon area is where you want to set the detection rules. Draw the area according to the actual
situation.
Steps
1. Go to VCA → Set Application → Tunnel Event Detection → Panoramic Rule Settings and click
Polygon Area.
2. Click Add Area.
3. Click to mark the corner points of the polygon area. Right click to complete drawing.
Note
You can click
●
Polygon areas cannot overlap.
●
Click on the area and you can drag the corner points to adjust the area.
●
4. Select the line type of the left and right side lines according to the actual situation.
5. Optional: Repeat the steps above to set multiple polygon areas.
Note
When there are multiple polygon areas, you can click on one area and click
6. Click Save.
Set Detection Scene
A detection scene is an area you want to monitor. If one detection scene cannot cover all the
intended monitoring areas, set multiple detection scenes.
Steps
1. Go to VCA → Set Application → ITS (Intelligent Transportation System) → Close-up Rule
Settings .
2. Optional: Click Lock to lock PTZ control to prevent the interruption from other PTZ related action
during configuration.
Normally, the PTZ control is automatically locked when you enter the configuration interface.
You can manually resume the lock when the countdown is over.
3. Select a Scene.
4. Check Enable to enable the scene.
5. Click the PTZ control buttons to adjust the scene to where you want to monitor.
6. Enter a Scene Name.
7. Select the Scene Direction according to the traffic direction in the scene.
8. Click Save.
TandemVu PTZ Camera User Manual
to enlarge the live view window. Press ESC on the keyboard to exit.
19
to delete it.