To adjust the CRT monitor alignment
This procedure must be performed by trained personnel. Adjustments are made with
the cover removed and power applied.
Do not touch the CRT monitor sweep board. High voltages exist on the sweep board that can
W A R N I N G
cause personal injury.
Equipment Required
Equipment
Alignment Tool
Turn off the logic analyzer, then disconnect the power cord. Remove the cover.
1 1
Refer to chapter 6, "Replacing Assemblies," for instructions to remove the cover.
Connect the power cord, then turn on the logic analyzer.
2
Insert the disk containing the functional performance verification tests into the disk
3
drive, then load the functional performance verification operating system into the
logic analyzer.
4–6
Critical Specification
Recommended
Model/Part
1
8710-1300