Replacing Assemblies
To remove and replace the disk drive assembly
To remove and replace the disk drive assembly
Using previous procedures, remove the following assemblies:
1
•
Handle
•
Rear Feet
•
Cover
Disconnect the two disk drive ribbon cables from the rear of both disk drives. Peel
2
the cables away from the double-sided tape used to secure the cables to the disk
drive bracket.
Disconnect the power cable from the rear of the hard disk drive.
3
Remove the two screws that attach the disk drive bracket to the power supply.
4
Slide the disk drive assembly toward the front of the instrument about 1/2 in.
5
(1.25 cm). Angle the rear of the bracket up and out of the chassis, then remove the
disk drive assembly completely out of the chassis by sliding the assembly toward the
rear of the instrument.
To remove the flexible disk drive from the bracket, remove the four screws that
6
attach the flexible drive to the bracket, two on each side.
To remove the hard disk drive, remove the four screws on top of the bracket that
7
attach the hard drive to the bracket. If a new hard disk drive is being installed, then
two rubber feet must be installed on the hard drive between the hard drive and the
power supply.
Reverse this procedure to install the disk drive assembly.
8
Check that the following assemblies are properly installed before installing the disk drive:
•
Monitor
•
Front Panel
•
Switch Actuator
•
CPU Board
•
Power Supply
6–6